Throttle linkage - 3.8 Series 1 (1961-64)
for rear carburettor on RHD models
E-Type 3.8 Series 1 from engine no. R2934 (1962-64)
Requires: 1
accelerator linkage, rear position
LHD models from engine no. R1001 to R2933
Requires: 1
accelerator linkage, rear position
LHD models from engine no. R2934
Requires: 1
accelerator linkage, intermediate position
Models from engine no. R1001 to R2933
Requires: 1
accelerator linkage, front position
Models from engine no. R1001 to R2933
Requires: 1
accelerator linkage, front position
Models from engine no. R2934
Requires: 1
made from steel and fully covered with zinc. Supplied in a 16 piece kit for RHD models
to engine no. R2933 (1961-62)
Requires: 1
made from galvanized steel that offers excellent corrosion protection. 16 piece kit for LHD models
to engine no. R2933 (1961-62)
Requires: 1
throttle spindle
Models from engine no. R1001 to R2933
Requires: 1
retaining coupling shaft on spindle
Models from engine no. R1001 to R2933
Requires: 2
retaining coupling shaft on spindle
Models from engine no. R1001 to R2933
Requires: 2
retaining coupling shaft on spindle
Models from engine no. R1001 to R2933
Requires: 2
throttle spindle
Models from engine no. R1001 to R2933
Requires: 3
retaining throttle lever on spindle
Models from engine no. R1001 to R2933
Requires: 3
retaining throttle lever on spindle
Models from engine no. R1001 to R2933
Requires: 3
retaining throttle lever on spindle
Models from engine no. R1001 to R2933
Requires: 3
choke between front an centre carburetter
Requires: 1
complete with screw. retaining choke cable to center carburettor
Requires: 1
