Control unit and lambda sensor
fuel injection - exchange
Series II, Series III to (VIN) 310612
Requires: 1
fuel injection - exchange
Series III from (VIN) 310612 to 326519
Requires: 1
fuel injection - exchange
Series III from (VIN) 310612 to 326520 to August 1985
Requires: 1
fuel injection - exchange
Series III without catalytic converter from August 1985
Requires: 1
fuel injection - exchange
Series III with catalytic converter from August 1985
Requires: 1
control unit
Requires: 1
control unit
Requires: 1
cold start and fuel pump relay
Requires: 1
fuel injection - exchange
Series II to engine no. 7P31112
Requires: 1
fuel injection - exchange
Series II from engine no. 7P31113, Series III to engine no. 7P42299
Requires: 1
Series II, Series III to engine no. 7P42299
Requires: 3
made from rubber with 47 mm outer diameter - for 38 mm hole and 10 mm cable, total height: 7.7 mm
Series II, Series III to engine no. 7P42299
Requires: 1
fuel injection
Series III from engine no. 7P42300 (cars with digital fuel injection)
Requires: 1
Series III from engine no. 7P42300 (cars with digital fuel injection)
Requires: 2
Series III from engine no. 7P42300 (cars with digital fuel injection)
Requires: 2
Series III from engine no. 7P42300 (cars with digital fuel injection)
Requires: 2
Series III from engine no. 7P42300 (cars with digital fuel injection)
Requires: 2
Series III from engine no. 7P42300 (cars with digital fuel injection)
Requires: 2
- non heated
Series III with catalytic converter from engine no. 7P42300 (cars with digital fuel injection)
Requires: 1
- heated
Series III with catalytic converter from engine no. 7P42300 (cars with digital fuel injection)
Requires: 1
test device for lambda sensor, measuring range from 0 to 1 volt, in steps of 0.05 volts, operates with 12 volt vehicle power supply
Requires: 1
for lambda oxygen sensors with 22 mm spanner size. The cut out socket provides a good grip without damaging the sensor cable, 3/8" drive
Requires: 1
