SU-HS2 internal carburettor MK3 - all European specifications, USA specification to October 1969
with valve
USA and Canada models from engine no. FE8155
Requires: 2
throttle spindle. For bodies with worn cast in bushes, useable on SU HS2 carburettors with 5/16" throttle spindle
For bodies with worn cast in bushes
Requires: 4
throttle spindle on front and rear carburettor - stainless steel reproduction
Requires: 2
and link - front carburettor
Requires: 1
and link - rear carburettor
Requires: 1
front carburettor
Requires: 1
for SU HS type carburettor - uprated 'unsinkable' type, made from closed cell Nitrile rubber foam, resistant to modern ethanol based fuels
Requires: 2
for SU-H, SU-HD and SU-HS type carburettors - superior replacement of needle valve and seat
Superior replacement of needle valve and seat. This valve is less likely to stick open or over fuel on run over
Requires: 2
with piston
Requires: 2
piston return - colour: red, spring rate: 4.5 oz
Standard type
Requires: 2
piston return - colour: yellow, spring rate: 8 oz
Uprated type
Requires: 2
fixed type - marked: BQ
Standard mixture for AUD257 carburettors
Requires: 2
fixed type - marked: DD
Standard mixture for AUD275 carburettors
Requires: 2
assembly. For SU-HS carburettors with fixed metering needle
Requires: 2
jet bearing
Part of our jet bearing kit 2735 (ill. 43)
Requires: 2
jet bearing
Part of our jet bearing kit 2735 (ill. 43)
Requires: 2
main jet
Part of our jet bearing kit 2735 (ill. 43)
Requires: 2
for two SU-HS2 type carburettors. Comprising service kit 214281 plus throttle discs and throttle spindles
Requires: 1
