Ignition coil, ignition leads and spark plugs
with push-in HT lead terminal and approx. 2.8 Ohm primary resistance. Non ballasted type
MK3
Requires: 1
with push-in HT lead terminal and approx. 2.8 Ohm primary resistance. Non ballasted type
MK3
Requires: 1
with push-in HT lead terminal and approx. 1.4 Ohm primary resistance. Ballasted type
MK4 and 1500
Requires: 1
with push-in HT lead terminal and approx. 1.4 Ohm primary resistance. Ballasted type
MK4 and 1500
Requires: 1
for ballasted ignition coil. 1.6 Ohm
MK4 to chassis no. FH45740 and FK28000.
From chassis no. FH50001 and FM1 the separate ballast resistor was replaced by a resistive wire built into the loom
Requires: 1
for Delco D200 and D204 plus Lucas 45D4 distributor with top entry cap. Identify by push fit ignition leads
Requires: 1
for Delco D200 and D204 plus Lucas 45D4 distributor with top entry cap. Identified by push fit ignition leads. HT lead set with 8 mm silicone jacket in yellow
Requires: 1
for ignition coil with 'Lucas' lettering. Size: 77 x 28 mm
Requires: 1
on ignition leads with 'firing order' for four cylinder models
Requires: 1
90° angled - plastic reproduction with Champion lettering
Requires: 4
straight - replacement type with 5 Kilo Ohm
Requires: 4
90° angled - fits directly to the spark plug
Requires: 4
60° angled - fits directly to the spark plug
Requires: 4
